mail : enquiry@bimoutsourcing.com
US Toll Free : (+1) 713 429 1909
About Metal furring contractors
we have been having a lot of trouble lately when screwing our ceilings to the mf ceiling furrings. occasionally the screws will screw in tight but most of the time they are going in and then just spinning before they have managed to countersink into the board properly.
The hilti drywall gun with collated attachment, it seems to be a bit better if i take the attachment off and put the nosecone on, but still does it sometimes and is not productive speed wise. ive tried hilti and senco collated screws and was thinking that it may be down to the metal we are using, were using arrow metal for this job which has been supplied as its about half the price of Lafarge metal, so I was thinking its probably a lot thinner gauge which is causing our problems.

- Awning installation
- Balcony, metal, installation
- Cathodic protection, installation
- Concrete form contractors
- Curtain wall, metal, installation
- Deck and grate, metal, installation
- Decorative steel, wrought iron
- Epoxy application contractors
- Erection, poured concrete form
- Falsework construction
- Fire escape installation
- Fireproofing buildings
- Forming contractor
- Forms for poured concrete,erecting
- Metal furring contractors
- Ornamental metal work installation
- Shutter installation
- Stairway, metal, installation
- Store front, metal frame, installation
- Welding, on site, contractors
Other Foundation
All contents of this page are taken from http://www.contractortalk.com/f49/screws-spinning-when-screwing-drywall-metal-ceiling-furring-71516/